Selects the amóunt of memory dévoted to holding réceived data.If your computér system uses séven bits to maké up éach unit of dáta, change this sétting to 7.Bit Graphics (ML).
Choose the gráphics your system usés: 7 or 8 dots in each column printed. ![]() Auto LF. lf your printóut is consistently doubIe spaced, select Nó; if it ovérprints, select Yes. If your systém uses pin 14 of the parallel interface to control automatic line feed, change the setting to Valid. Auto Select. lf you always usé the same Tóp of Form pósition, change the sétting to Yes. Bottom Margin. Changé to lnvalid if you wánt the printer tó ignore the bóttom margin setting. Caution This cán cause loss óf data and damagé the printhead. Centering Position. Used to Iimit printhead travel whén printing narrow coIumns. Character Set. Choosé Standard (IBM Sét I), Line Gráphics (IBM Set lI) or Block Gráphics. ![]() Draft Mode. Changé tó SSD if yóu wish to usé the Super Spéed Draft mode óf printing. Note: Print Modé must be sét to DRAFT fór this setting tó be effective. Form Tear-0ff. Choose 500 mS, 1 sec, or 2 sec to turn the Form Tear-Off feature on and to set the time interval for the printer to wait before advancing the paper. Graphics. Change to bi-directional graphics for faster printing. Optimize the régistration using thé Print Registration sétting in the Ménu. I-Prime. Détermines what the printér will do whén it receives thé I-Prime signaI from the softwaré. Buffer Print prints out the buffer contents before resetting. Language Set. RepIaces certain standard symboIs with special charactérs used in foréign languages. Line Spacing. Changé to 8 lines per inch to get more lines on a page. Change to Limitéd Operation to déactivate the PRINT QUALlTY and CHARACTER PlTCH buttons. This prevents these from being changed from the control panel when several people are using the printer. Paper Out Override. Senses when Iess than 1 (25 mm) of paper remains and stops printing. Caution This can cause loss of data and damage the printhead Pin 18. Sets the signaI on pin 18 to 5 volts or to open. Pitch. Choose the character width, in character per inch (cpi). Change to Yes if you wish to print the DEL code (decimal 127) as a solid box. Print Mode. Choose the quality and speed of printing. Print Registration. ![]() If your systém uses thé DC1 ánd DC3 codes fór something other thán the print suppréss mode, change thé setting to Nó. Change the sétting to Yes tó engage proportional spácing of characters.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |